jenn
New Member
Posts: 4
|
Post by jenn on Nov 14, 2018 19:38:55 GMT
Help! I have tried everything! I cannot reset this oil change light!
Bus is 2013 IC RE Maxxforce DT.
Have tried the cruise switches about a 100 times. Have tried a sequence with the brake and throttle pedals I found on School Bus Fleet Forum. Have tried throttle pedal three times. Have tried clearing codes in NED and also reset oil change monitor parameters. Have looked in Owners manual. No procedure found. Have looked in On Command, says to use the cruise switches but no procedure outlined.
The cruise switches procedure I'm using is Brake on Key on Cruise on off on Resume switch press four times and hold on the fifth time.
Nothing works! Thank you for your help!!!!
|
|
|
Post by highpockets on Nov 14, 2018 20:44:53 GMT
I think you can turn off that feature in the parameters
|
|
|
Post by MiketheMech on Jan 15, 2019 1:08:19 GMT
Jenn try this with cruise switches - key on press on and set/resume at same time twice, this may clear inactive faults, then with key still on turn left signal on and press on and set/resume twice again, this should reset oil change monitor, let me know and I will look into further
|
|